Usb to serial hyperterm drivers#
Usb to serial hyperterm update#

Click Configure, and make sure that the port settings match those required by the system you are connecting to. Select your COM port under connect using. Enter a name for your connection and click OK. Open the HyperTerminal Software and create a new connection. Caution: Very few devices have standard RS-232 +/- 12V serial ports, but in many OpenWrt-supported devices the serial ports operate at TTL voltage (sometimes 5V, most often 3.3V) levels, meaning you cannot use a standard serial or USB to serial cable: it will fry your board.

USB connections apparently don't use COM ports. Connect the system you are monitoring to the serial port.

My hardware in use is a BS2 on a 'Board of Education' that is connected to my PC through a serial/USB adapter that came with the BOE.Īll that said - here's my question.HyperTerm (built into Windows XP) requires the selection of a serial COM port. I use it a lot and get minimal errors (almost none, I think I had like 1-2 errors in one years use).

Usb to serial hyperterm update#

Step 5: After that, check the scan results and click on the Update Now button beside the Prolific USB to serial driver. Step 4: Wait for the scanning to be completed.

Step 3: Open Bit Driver Updater and click on Scan. Ive recently bought an Odroid H2+ PC which has a UART on the GPO pins so I hope it can be used for RS485 If you have moe questions, Ask in the Linuxcnc forum as you will get more help than here. It adds an entry in Device Manager under the USB root hub (named USB to Serial Link) and applications using the serial port see it as an independant RS-232 port, the USB port is transparent to them. Step 2: Run the downloaded file and follow the on-screen instructions to finish the installation. I've read through some web pages that describe what goes on with USB. You need a DB9 serial port on your PC and a RS485 converter.I've read through the manual pages on SERIN/SEROUT and even found an old Nuts & Volts column deciphering what's in the manual. When I try and use MAX or Basic Serial Read/Write.vi neither works. After sending the break, I disconnect from HyperTerm, and connect via CRT (also using Port 1), and carry on. For now, I just fire up HyperTerm and assign it to Serial Port 1, through which I connect to the router.

Usb to serial hyperterm drivers#

I downloaded the usb drivers from the manufacturers website and can talk to the device using Hyperterminal. Ive tried simply entering ctrl-Break (which works using HyperTerminal in XP SP2). OK - so I've decided to play around with SERIN/SEROUT in an attempt to set up a user interface on the PC via HyperTerm so I might input data to the BS2 with which it will use when running the program. I am using a device (power meter.Maestro) that talks over a USB Cable.